Vietnamese dictionaries for mobile phones

processor The four steps which the CPU carries out for

each machine language instruction: fetch, decode, execute,

and store. These steps are performed by the control unit,

and may be fixed in the logic of the CPU or may be programmed

as microcode which is itself usually fixed (in ROM) but

may be (partially) modifiable (stored in RAM).

The fetch cycle places the current program counter contents

(the address of the next instruction to execute) on the

address bus and reads in the word at that location into the

instruction register (IR). In RISC CPUs instructions are

usually a single word but in other architectures an

instruction may be several words long, necessitating several

fetches.

The decode cycle uses the contents of the IR to determine

which gates should be opened between the CPU's various

functional units and busses and what operation the ALU(s)

should perform (e.g. add, bitwise and). Each gate allows

data to flow from one unit to another (e.g. from register 0

to ALU input 1) or enables data from one output onto a certain

bus. In the simplest case ("horizontal encoding") each

bit of the instruction register controls a single gate or

several bits may control the ALU operation. This is rarely

used because it requires long instruction words (such an

architecture is sometimes called a very long instructionword architecture). Commonly, groups of bits from the IR are

fed through decoders to control higher level aspects of the

CPU's operation, e.g. source and destination registers,

addressing mode and ALU operation. This is known as

vertical encoding. One way RISC processors gain their

advantage in speed is by having simple instruction decoding

which can be performed quickly.

The execute cycle occurs when the decoding logic has settled

and entails the passing of values between the various function

units and busses and the operation of the ALU. A simple

instruction will require only a single execute cycle whereas a

complex instruction (e.g. subroutine call or one using memory

indirect addressing) may require three or four.

Instructions in a RISC typically (but not invariably) take

only a single cycle.

The store cycle is when the result of the instruction is

written to its destination, either a register or a memory

location. This is really part of the execute cycle because

some instructions may write to multiple destinations as part

of their execution.

(1995-04-13)